Pick the right day and the right caulk
Caulk needs a dry day between about 40 and 90 degrees, with no rain coming for a day. Use paintable siliconized acrylic where the window trim meets siding or stucco. Save pure silicone for glass-to-metal joints — paint will not stick to it later.
Duration: 10 min
Cut out every bit of the old caulk
Score both edges of the old bead with the utility knife, then dig it out with the caulk removal tool and putty knife. New caulk does not stick to old caulk — any old bead you leave behind becomes the spot that fails first.
Duration: 40 min
Clean the joint down to solid material
Wire-brush dirt, dust, and loose paint out of the joint and wipe it with a dry rag. If you used caulk softener, wipe the joint clean and let it dry fully — caulk will not bond to a wet or slimy joint.
Duration: 15 min
Fill deep gaps with backer rod first
Any gap deeper than about 3/8 inch or wider than 1/4 inch gets foam backer rod pressed in first, about 1/4 inch below the surface. Caulk is a seal, not a filler — a deep joint filled solid with caulk shrinks, splits down the middle, and fails in one season.
Duration: 15 min
Tape both sides, then run the bead
Lay painter's tape along both sides of the joint. Cut the tube tip small — you can always cut it bigger. Hold the gun at 45 degrees, keep it moving at a steady pace, and push the bead ahead of the tip so it fills the joint instead of sitting on top of it.
Duration: 30 min
Tool the bead and pull the tape
Run a wet finger or a damp putty knife down the bead once to press it into both sides of the joint. Pull both tape strips right away, while the caulk is still wet, angling them away from the bead.
Duration: 10 min
Leave the drain paths open
Do NOT caulk over the small weep holes at the bottom of vinyl or aluminum window frames, and do not seal the bottom edge where a window is meant to drain. Water that gets behind the frame needs a way out — seal the drains shut and that water goes into your wall instead.
Duration: 5 min
Let it cure, then check your work
Keep water off the new beads for at least 24 hours. Next windy day, walk the house and check every window — no gaps, no splits, no beads that pulled away from one side. Touch up misses now, not after the first storm.
Duration: 10 min
If the wood trim or sill is soft and rotted, the window frame is racked or won't close, or the glass is fogged between panes — caulk is not the fix. Rot and failed glass units need a window pro or carpenter first.
AyX — Accuracy Yields Xcellence.