Service an Evaporative (Swamp) Cooler for Summer
Category: Mechanical ·
Difficulty: Beginner ·
Time: 1.8h ·
Estimated cost: $60
Tools needed
- Garden hose
- Shop vacuum
- Screwdriver set
- Adjustable wrench
- Old towels
- Breaker lockout hasp and padlock
Materials needed
- Evaporative cooler pads (set) (1 set)
- Cooler cleaner/descaler (1 bottle)
- Replacement float valve (1 ea)
- Cooler cover (for winter) (1 ea)
Execution steps
Kill power and water
Shut off the breaker and lock it out — hasp and padlock on the breaker so nobody flips it back on while your hands are in the unit — then confirm the unit is dead before you touch anything. Shut off the water supply valve too. A swamp cooler with live power and water is how people get hurt.
Duration: 5 min
Pull the pads and side panels
Remove the louvered side panels. Slide out the old pads — if they are crusty, torn, or smell like a swamp, they are done.
Duration: 15 min
Drain and scrub the pan
Pull the drain plug and let the pan empty. Scrub mineral scale with cooler cleaner and rinse. A clean pan is the difference between cool air and a science experiment.
Duration: 25 min
Vacuum the water lines
Shop-vac the distribution tubes and spider arms. Mineral buildup chokes water flow to the pads — clear tubes mean even cooling.
Duration: 15 min
Check the float and pump
Lift the float — water should shut off at the marked level. Pull the pump, clear debris from the intake screen, and confirm it runs. Replace the float valve if it sticks.
Duration: 15 min
Install new pads
Soak new pads in the hose before installing — dry pads cool nothing for the first hour. Seat them fully in the frames with no gaps.
Duration: 15 min
Reassemble and test
Panels back on, water on, power on. Run the pump alone for 10 minutes to saturate pads, then start the blower. Check for leaks at every connection.
Duration: 20 min
Safety first
- GOOD — Kill the breaker AND the water before you touch anything. Water plus 120 volts is not a combination you negotiate with.
- GOOD — Roof-mounted unit? The ladder rules are the whole job: inspect the ladder first, set it at a 4-to-1 angle on firm level ground with the top 3 ft past the eave, keep three points of contact, never stand on the top three rungs, and stay within its rated load.
- GOOD — Soak new pads before installing. Dry pads blow hot dusty air for an hour and make you think something is broken.
- GOOD — Clean the pan every spring. Mineral scale is where the smell, the bacteria, and the weak cooling all start.
- BAD — Run the blower with dry pads and you are just running a very expensive fan. The pump has to saturate the pads first.
- BAD — Ignore a stuck float and the pan overflows all summer — down the roof, into the attic, onto the drywall. A $9 valve prevents a $2,000 ceiling.
- HOLY SHIT — Reach into a live cooler to clear a jammed pump and you can take 120 volts through standing water. People die this way every summer in Arizona. Breaker off. Every time.
When to hire a pro
If the motor hums but won't spin, the blower wheel is seized, or the unit is on a roof you don't want to be on — call an HVAC tech.
Back to all DIY Guides ·
AyX Estimator — Take the guess out of construction.
AyX — Accuracy Yields Xcellence.