Fix a Door That Sticks or Won't Latch
Category: Doors ·
Difficulty: Beginner ·
Time: 1.5h ·
Estimated cost: $15
Tools needed
- Drill/driver
- Phillips screwdriver
- Pencil
- Sandpaper (100 and 150 grit) or a block plane
- Hammer
Materials needed
- 3-inch wood screws (for hinge repair) (1 pk)
- Wood filler (1 tube)
- Graphite lock lubricant (1 tube)
Execution steps
Find where it's actually rubbing
Close the door slowly and watch the gaps. The tight spot shows shiny paint, scuffs, or a gap that's wide at the top and closed at the bottom. Mark the rub spot with the pencil. Nine sticking doors out of ten are a hinge problem, not a door problem — check hinges before you ever touch a plane.
Duration: 10 min
Tighten the hinges — with screws that reach the stud
Tighten every hinge screw. Any that spin are stripped: pull the top hinge's screws one at a time and replace them with 3-inch screws that pass through the jamb into the wall stud. Long screws pull a sagging door back up and fix most latch misses on the spot. Do the top hinge first — that's where doors sag from.
Duration: 20 min
Check the latch against the strike plate
If the door hangs straight but the latch clicks against the edge of the strike plate, mark where the latch bolt hits with lipstick or chalk, close the door, and read the mark. A small miss adjusts out by loosening the strike plate and shifting it; a bigger miss means filing the plate's opening or shimming it — match the fix to the mark, not a guess.
Duration: 15 min
Only now trim the door — a little at a time
If the hinges are tight and it still rubs (common in monsoon season when wood swells), take the door off its hinges, and sand or plane ONLY the marked rub spot. Take a little, rehang, test. You can always take more off; you cannot put wood back.
Duration: 30 min
Seal what you trimmed and finish up
Paint or seal any bare wood you exposed — raw wood drinks moisture and swells right back. A puff of graphite in the latch keeps it moving. Close the door ten times: it should swing free and latch with a click, no lifting, no shoving.
Duration: 15 min
Safety first
- GOOD — Hinges first, plane last. The long-screw hinge fix costs five dollars and ten minutes, and it's the real repair for most sticking doors.
- GOOD — Take the door off and work it on sawhorses if you're trimming it. Planing a hanging door is how cuts and gouged jambs happen.
- BAD — Plane the door in July because it sticks in the humidity and you'll have a door with a half-inch gap rattling all winter. Sand the paint ridge first — swollen paint, not swollen wood, is often the whole problem.
- BAD — Bend hinges with a hammer blow to 'adjust' them as a first move. It's a last-resort trick that can crack the jamb; the screw fix solves the same sag without it.
- HOLY SHIT — An exterior door that suddenly won't latch or has a fast-growing gap isn't always weather — it can be the frame moving from foundation shift or a rotted sill giving way. If an outside door changes fast, or you find soft wood at the bottom of the frame, stop adjusting and get the frame and foundation looked at — a door that won't lock is a safety problem, not a carpentry nuisance.
When to hire a pro
Rotted jambs or sills, a frame visibly out of square, cracks in the wall above the door, or a door that keeps moving after two fixes — that's foundation or framing movement, and it needs a carpenter or foundation pro, not more sanding.
Back to all DIY Guides ·
AyX Estimator — Take the guess out of construction.
AyX — Accuracy Yields Xcellence.