Replace a Broken Sprinkler Head
Category: Landscaping ·
Difficulty: Beginner ·
Time: 0.9h ·
Estimated cost: $15
Tools needed
- Small shovel or trowel
- Towel
- Adjustable wrench
Materials needed
- Replacement sprinkler head (match type) (1 ea)
- PTFE thread tape (1 roll)
- Swing pipe / funny pipe elbow (spare) (1 ea)
Execution steps
Identify the head type
Pop-up spray, rotor, or drip emitter — replace like with like. A rotor where a spray head was will flood one spot and starve the rest.
Duration: 5 min
Dig it out
Cut a neat plug of sod around the head and dig down to expose the riser. Keep the dirt on the towel so the lawn goes back clean.
Duration: 15 min
Unscrew the old head
Twist the head off the riser by hand. If the riser comes up with it, hold the riser with a wrench — you do not want dirt falling into the open line.
Duration: 5 min
Flush the line
Turn the zone on for 10 seconds with the head off. This blasts grit out of the line that would instantly clog the new head.
Duration: 5 min
Install the new head
Wrap the riser threads with PTFE tape, thread the new head on hand-tight plus a quarter turn. Set the height so the cap sits flush with the soil — mowers eat proud heads.
Duration: 10 min
Aim and test
Run the zone. Adjust the arc and distance per the head's instructions — water the plants, not the sidewalk. Backfill and replace the sod plug.
Duration: 15 min
Safety first
- GOOD — Flush the line before installing the new head. Ten seconds of water saves you from digging it back up to clear grit.
- GOOD — Set the head flush with grade. Every head sticking up is a future mower casualty.
- BAD — Mix head types on one zone and the watering goes uneven — rotors and sprays put down water at totally different rates.
- BAD — Skip the PTFE tape and the joint weeps underground for months. You'll find it when the water bill doubles.
- HOLY SHIT — If you smell sewage or the water coming out of the line is black and foul, stop — you may have broken into a sewer or septic line, not irrigation. Cap it and call a pro before you contaminate the yard.
When to hire a pro
A cracked main line, a valve that won't open, or wiring problems at the controller — those are system repairs, not a head swap.
Back to all DIY Guides ·
AyX Estimator — Take the guess out of construction.
AyX — Accuracy Yields Xcellence.