Replace a Rotted Fence Post
Category: Exterior ·
Difficulty: Intermediate ·
Time: 2.3h ·
Estimated cost: $40
Tools needed
- Post-hole digger or shovel
- Level
- Drill/driver
- Pry bar
- Tape measure
- Wheelbarrow
Materials needed
- 4x4 pressure-treated post (ground contact rated) (1 ea)
- Fast-set concrete mix (50 lb) (2 bag)
- Gravel (for hole base) (1 bag)
Execution steps
Call 811 before you dig — every time
Call 811 (or your state's one-call) at least a few days before you dig and get the buried lines marked. Fence lines run right where utilities run. This step is free and it is not optional.
Duration: 10 min
Brace the fence and take the rails off the post
Screw a temporary brace from the fence panels to a stake so the run stays standing while the post is out. Unscrew or pry the rails off the bad post. If the panels drop or rack now, you'll fight them for the rest of the job.
Duration: 20 min
Dig out the old post and its concrete
Dig around the old post footing and rock the post to loosen it, then lever the whole thing — post and concrete plug — out of the hole. Digging the plug out beats breaking it up in the hole. Widen the hole a few inches past the old one so the new concrete gets a clean grip on solid ground.
Duration: 45 min
Set the new post on gravel
Pour a few inches of gravel in the bottom of the hole for drainage — a post sitting in a concrete cup of water rots from the bottom up. Set the new post in, line it up with the fence run, and check it plumb on two sides with the level.
Duration: 15 min
Pour the concrete and hold it plumb
Brace the post with two scrap boards screwed to stakes. Pour the fast-set mix in dry around the post per the bag, add water, and re-check plumb before it grabs — you have minutes, not an hour. Crown the top of the concrete slightly so rain runs away from the post instead of pooling against it.
Duration: 30 min
Rehang the rails after it sets
Wait the time the bag states before putting load on the post. Re-screw the rails to the new post, pull the temporary braces, and sight down the fence line — it should run straight through the new post.
Duration: 20 min
Safety first
- GOOD — Call 811 first, even for 'just one fence post, same hole.' Lines get moved, holes get widened, and the one time you skip it is the time the gas line is 6 inches over.
- GOOD — Buy a ground-contact-rated post and set it on gravel. Most fence posts rot at the ground line because the bottom sat in water — drainage is what makes this repair last.
- BAD — Set the new post in the old broken concrete or in plain dirt to save a bag of mix. You'll be digging the same hole again in two years.
- BAD — Load the post the same afternoon because the concrete 'feels hard.' Fast-set still needs its stated cure before it holds a fence against wind.
- HOLY SHIT — Dig a post hole by feel in an unmarked yard and you can put a digger bar through a gas line, a power feed, or a fiber line. A gas line hit means drop the tools, walk away, and call 911 from a distance — not finish the hole, not next week. 811 first. Every hole.
When to hire a pro
If several posts in a row are rotted, the whole line leans, or the fence sits on a property line in dispute — that's a fence contractor's job. And any hole that turns up an unmarked line, a strong gas smell, or conduit you can't identify: stop and call the utility, not a buddy.
Back to all DIY Guides ·
AyX Estimator — Take the guess out of construction.
AyX — Accuracy Yields Xcellence.